An interface for a photovoltaic module to an ad-hoc, low voltage, DC distributed grid

Simple item page
dc.contributor.authorDangor, Mohammed Raees Ebrahim
dc.date.accessioned2020-09-02T07:18:04Z
dc.date.available2020-09-02T07:18:04Z
dc.date.issued2019
dc.descriptionA dissertation submitted in partial fulfilment of the requirements for the degree of Master of Science in Engineering to the Faculty of Engineering and the Built Environment, University of the Witwatersrand, 2019en_ZA
dc.description.abstractThis research has contributed to the advancement of the Personal Consumer (PeCo) grid concept and has furthered the technology from a conceptual prototype to becoming a viable rural electrification solution. The PeCo grid is a conceptual ad-hoc, 12V, DC distributed grid aimed at providing an electrification solution for singe rural households. The grid is composed of an interconnection of renewable energy sources, battery storage and loads. A shortcoming of the PeCo grid, exposed on the first experimental prototype grid, was that undesirable over-voltages occurred during load removal events due to an over-supply of power to the grid after the load was disconnected. This research entails the development of an interface for a photovoltaic (PV) module to the PeCo grid that aims to overcome this shortcoming and to extend the capabilities of and further the technology. At the interface, the voltage of the PV module is matched to the grid voltage. Power flow from the PV module to the grid is controlled according to a control strategy modelled as a state diagram and executed by a micro controller unit (MCU). The power converter at the interface is a Flyback converter operating in discontinuous conduction mode (DCM). A model was derived to estimate the primary-side inductor current of a DCM Flyback converter and applied to perform model-based maximum power point tracking (MPPT). This obviated the need for any current sensors at the interface. The response of the MCU to a load removal event was tested and validated to overcome the shortcoming of the experimental grid. The model-based MPPT solution was tested using the PeCo grid as a test platform and validated to successfully perform MPPT. The real world application of the interface was validated and the technology deemed suitable for rural electrification.en_ZA
dc.description.librarianTL (2020)en_ZA
dc.facultyFaculty of Engineering and the Built Environmenten_ZA
dc.format.extentOnline resource (various pagings)
dc.identifier.citationDangor, Mohammed Raees Ebrahim. (2019). An interface for a photovoltaic module to an Ad-Hoc, low voltage, DC distributed grid. University of the Witwatersrand, https://hdl.handle.net/10539/29421
dc.identifier.urihttps://hdl.handle.net/10539/29421
dc.language.isoenen_ZA
dc.schoolSchool of Mining Engineeringen_ZA
dc.subject.lcshPhotovoltaic cells
dc.subject.lcshPhotovoltaic power generation
dc.titleAn interface for a photovoltaic module to an ad-hoc, low voltage, DC distributed griden_ZA
dc.typeThesisen_ZA
Files
Original bundle
Now showing 1 - 2 of 2
No Thumbnail Available
Name:
Abstract.pdf
Size:
18.89 KB
Format:
Adobe Portable Document Format
Description:
Abstract
Download
No Thumbnail Available
Name:
Dissertation.pdf
Size:
34.94 MB
Format:
Adobe Portable Document Format
Description:
Main Work
Download
License bundle
Now showing 1 - 1 of 1
No Thumbnail Available
Name:
license.txt
Size:
1.71 KB
Format:
Item-specific license agreed upon to submission
Description:
Download
Collections
ETD Collection