3. Electronic Theses and Dissertations (ETDs) - All submissions
Permanent URI for this communityhttps://wiredspace.wits.ac.za/handle/10539/45
Browse
Search Results
Item Investigation into the use of variable speed drives to damp mechanical oscillations(2016) Blaski, GregAn investigation was conducted into how a variable speed drive can provide a damping torque when mechanical oscillations are present. The modeling of mechanical oscillations via an analogous electrical circuit was performed. Simulation was used to demonstrate how a variable speed drive is able to damp speed oscillations using Direct Torque Control (DTC). Damping of mechanical oscillations is done by means of the variable speed drive providing a damping torque component that is in-phase with the speed deviation. The simulation showed that by applying a small torque component with the speed variation results in torque oscillations being damped by 60% after the initial disturbance. Damping is further improved by applying a torque component equal to the speed variation resulting in the oscillations being damped by 80% when compared to the initial disturbance.Item Experimental investigation into a passive auto-tuning mass damper for structural vibration control of a MDOF system(2016) Naicker, Elizabeth NicoleA Passive Auto-Tuning Mass Damper with Pulley connections (PATPD) is a vibration control device that consists of a box filled with silica sand on roller supports. The silica sand provides the mass of the damper. The PATPD is connected to the structure to be controlled by a group of ropes and pulleys; it is free to move in any translational direction. The pulleys and rope transfer a driving force to the damper, caused by the movement of the structure. The mass provides an inertial force which, in addition to the driving force of pulleys, dissipates energy providing the vibration control of the structure. Firstly, the test model underwent ‘PATPD Efficiency tests’ where the model was subjected to free translational, torsional and coupled vibration both with and without damper. This procedure was then repeated for forced harmonic excitation and the control effect for both analysed. These tests aimed to demonstrate the effectiveness of the PATPD at controlling structural vibrations. The results indicate that the PATPD provided at least 99% reduction to first natural frequency Power Spectral Density (PSD) peak for all tests, with relatively minimal increases for others. The model then underwent ‘Parameter Tests’ where the damper characteristics were changed and test procedure above repeated. These tests aimed to investigate the effect of the property changes of the PATPD on its ability to control free and forced vibration. The results indicate that (a) the PATPD provided significant reduction to first natural frequency PSD peak for all tests and (b) the properties of the PATPD affected the amount of control provided to the structure thus optimization of the PATPD could result in improved control effect. The models’ ‘Dynamic Properties’ namely model mass and stiffness were changed and test procedure repeated. These tests aimed to demonstrate the auto-tuning or adaptivity of the PATPD in its ability to control free and forced vibration. The results indicate that for all tests performed the PATPD provided significant reduction to first natural frequency PSD peak for all tests, with relatively minimal increases for others. The PATPD worked over a wide frequency band and was able to adapt to frequency changes providing significant control effect. Additional forced vibration tests under specific frequencies close to and far away from the models’ natural frequency demonstrates PATPD adaptability and efficiency. In addition tests under random excitation (as could be expected for earthquake loading) demonstrated PATPD positive control effect, adaptability and efficiency.