Faculty of Science

Permanent URI for this communityhttps://wiredspace.wits.ac.za/handle/10539/20140

For queries regarding content of Faculty of Science please contact Salome Potgieter by email : salome.potgieter@wits.ac.za or Tel : 011 717 1961

Browse

Filters

2015 - 20162

Settings

Subject: search.filters.subject.Uranium

Search Results

Now showing 1 - 2 of 2
  • Thumbnail Image
    Item
    Selective adsorption of uranium (VI) on NaHCO3 leached composite γ-methacryloxypropyltrimethoxysilane coated magnetic ion-imprinted polymers prepared by precipitation polymerization
    (South African Chemical Institute, 2015) Tavengwa, N.T.; Cukrowska, E.; Chimuka, L.
    Ion imprinted nano-magnetic composite polymers for selective removal of hexavalent uranium were prepared by a precipitation polymerization technique in the presence of γ-methacryloxypropyltrimethoxysilane (γ-MPS) coated magnetite and other pre-polymerization reagents. The synthesized magnetic polymers were then leached with NaHCO3 to produce magnetic ion imprinted polymers (IIPs) with fabricated adsorption sites complementary to the uranyl ions in terms of size and shape. Several parameters were investigated to obtain conditions which gave the optimum adsorption of the uranyl onto the magnetic IIPs and their corresponding controls, magnetic ion non-imprinted polymers (NIPs). The optimum amount of magnetic sorbent, initial concentration and contact time were 50 mg, 2.5 mg L-1 and 45 min, respectively. The adsorption capacity of the magnetic IIP (1.15 ± 0.01 mg g-1) was higher than that of the magnetic NIP (0.93 ± 0.02 mg g-1). This indicated that the former had a somewhat higher affinity for U(VI) than the later. The magnetic polymers also displayed good selectivity of the order: U(VI) > Ni(II) > Mg(II). After six cycles of use, the magnetic polymers illustrated good stability and reusability.
  • Thumbnail Image
    Item
    Application of maghemite nanoparticles as sorbents for the removal of Cu(II), Mn(II) and U(VI) ions from aqueous solution in acid mine drainage conditions.
    (Springer, 2016-06) Etale, A.; Tutu, H.; Drake, D.C.
    The adsorptive removal of Cu(II), Mn(II) and U(VI) by maghemite nanoparticles (NPs) was investigated under acid mine drainage (AMD) conditions to assess NP potential for remediating AMD-contaminated water. The effects of time, NP and metal concentration, as well as manganese and sulphate ions were quantified at pH 3. Adsorption of all three ions was rapid, and equilibrium was attained in 5 min or less. 56 % of Cu, 53 % of Mn and 49 % of U were adsorbed. In addition, adsorption efficiencies were enhanced by >= 10 % in the presence of manganese and sulphate ions, although Cu sorption was reduced in 1: 2 Cu-to-Mn solutions. Adsorption also increased with pH: 86 % Cu, 62 % Mn and 77 % U were removed from solution at pH 9 and increasing initial metal concentrations. Increasing NP concentrations did not, however, always increase metal removal. Kinetics data were best described by a pseudo-second-order model, implying chemisorption, while isotherm data were better fitted by the Freundlich model. Metal removal by NPs was then tested in AMD-contaminated surface and ground water. Removal efficiencies of up to 46 % for Cu and 54 % for Mn in surface water and 8 % for Cu and 50 % for Mn in ground water were achieved, confirming that maghemite NPs can be applied for the removal of these ions from AMD-contaminated waters. Notably, whereas sulphates may increase adsorption efficiencies, high Mn concentrations in AMD will likely inhibit Cu sorption.