ETD Collection

Permanent URI for this collectionhttps://wiredspace.wits.ac.za/handle/10539/104


Please note: Digitised content is made available at the best possible quality range, taking into consideration file size and the condition of the original item. These restrictions may sometimes affect the quality of the final published item. For queries regarding content of ETD collection please contact IR specialists by email : IR specialists or Tel : 011 717 4652 / 1954

Follow the link below for important information about Electronic Theses and Dissertations (ETD)

Library Guide about ETD

Browse

Filters

20191

Settings

Author: search.filters.author.Tumureebire, Patrick AtwineHas files: Yes

Search Results

Now showing 1 - 1 of 1
  • No Thumbnail Available
    Item
    Analysis of fracture growth models for hydraulic fracturing of shale gas deposits in the karoo, South Africa
    (2019) Tumureebire, Patrick Atwine
    Prediction of fracture dimensions during propagation of a hydraulically induced fracture for well stimulation is essential for the design of a stimulation treatment. This study seeks to better understand the mechanisms of hydraulic fracturing through computational modelling of the fracture growth up to a specific time in MATLAB. The computations were based on three existing theories of fracture propagation: the Khristianovitch, Geertsma and de Klerk (KGD) model, Perkins and Kern model (PKN) and Pseudo 3D model. Owing to the absence of raw data for the Whitehill formation in the Karoo, analogous shale rock from the United States of America was used as a basis for the study. The MATLAB computations were thus performed based on the following rock properties: Shear modulus = 1.466 x 105Psi; Drained Poisson’s ratio = 0.2; Fluid Viscosity = 1cp; Pumping rate = 62.5bbl/min; In-situ stress = 3200Psi; Wellbore radius = 0.2ft; Passed time = 0.3min. This report documents the differences in height, length, width, and pressure, predicted by the 2D and 3D models for the same set of input parameters. It is shown that the growth of the fracture for the 2D models yield much shorter lengths than the 3D model. It is also seen that the wellbore pressure predicted by the PKN model, in contrast to the KGD model, increases to 2.564 x 105 psi. as the fracture length increases. The pressure predicted by the P3D model increases to a peak of 1.411 x 10 6 psi at t = 0.24sec before declining to a final 7.709 x 105 psi. Though the report proposed an understanding of the mechanisms of hydraulic fracturing in the Karoo, and even obtained solutions, it is limited to simulation models without application to field data.