Browsing by Author "Harding, K.G."
Now showing 1 - 8 of 8
Results Per Page
Sort Options
Item Critical evaluation of the chemical composition of acid mine drainage for the development of statistical correlations linking electrical conductivity with acid mine drainage concentrations(Elsevier, 2022-05-07) Smith, J.; Sheridan, C.; van Dyk, L.; Harding, K.G.Item Critical evaluation of the chemical composition of acid mine drainage for the development of statistical correlations linking electrical conductivity with acid mine drainage concentrations(Elsevier, 2022-05-06) Smith, J.; Sheridan, C.; van Dyk, L.; Harding, K.G.The design an effective treatment processes for the remediation of acid mine drainage (AMD) requires an understanding of the composition of the AMD water. The pH and elemental composition of AMD waters are site specific and are dependent on the regional geology, and environmental factors. To establish the chemical and physical characteristics of two AMD sites located in the Mpumalanga coal mining region, South Africa, samples were taken between February 2018 to April 2019. These data were compared against regulatory legislation, and the potential health effects of exposure indicated. Strong correlations were noted between parameters and statistical evaluation demonstrated that electrical conductivity (EC) could be a useful correlative for prediction of total acidity, dissolved iron, and sulfur concentrations in acidic AMD waters. From these findings, empirical correlations were used to derive regression equations which were used to derive the EC values corresponding to the respective water quality limits for TDS, dissolved iron, and sulfur to provide a rapid method for testing compliance. Given the site specificity of AMD composition, this approach is intended as a proof of concept for the development of a methodology for adaption at other AMD sites. The regression equations should not be considered as universal to all AMD sites and EC should also not be used as a replacement for more complete chemical analysis.Item Eco-efficiency assessment of pork production through life-cycle assessment and product system value in South Africa(EDP Sciences, 2022-05-20) Qalase, C.; Harding, K.G.The consumption of pork as a source of animal protein has increased worldwide, especially in developing countries such as South Africa. The increase in pork demand is putting pressure on the natural environment, and the costs of production are increasing. This study sought to determine what is the eco-efficiency of pork production in a South African context. It also was meant to determine which processes in the value chain have low eco-efficiencies. Lastly, it sought to find what strategies could be recommended to improve overall eco-efficiency. Eco-efficiency was assessed by following the requirements of the International Standards Organisation ISO 14045 standard, which requires that the Life cycle assessment (LCA) method and product system value be combined. The environmental life cycle costing (LCC) method was used to determine the product system value (Value Added) of pork production. The functional unit was 1 kg of pork carcass, specifically from the cradle to the abattoir gate. The findings indicated that the pig farm and abattoir were the processes that had low eco-efficiencies and eco-efficient strategic improvements could be made. Mitigation strategies could be developed to concentrate on the production of animal feed and the use of renewable energy sources at the abattoir. The use of water could be improved by automation of the abattoir processes. Therefore, this study achieved its goal as economic and environmental areas of interest were identified in this specific case study for South Africa. This framework could be extended to study the eco-efficiency of other meat production chains and other sectors.Item Evaluation of Fuel Quality of Invasive Alien Plants and Tropical Hardwoods as Potential Feedstock Materials for Pyro‑Gasifcation(Springer, 2021-09-01) Okoro, N.M.; Ikegwu, U.M.; Harding, K.G.; Daramola, M.O.INTRODUCTION: Despite several studies carried out on the efects of the fuel properties of raw biomass on the fnal fuel properties of the biofuel after a thermochemical conversion, an identifcation and grading of various biomass types with respect to the level of their viability for pyro-gasifcation has not been established. OBJECTIVES: The primary objective of this study was to identify and rank eight waste wood feedstocks based on the suitability of their fuel properties for an efcient pyro-gasifcation using experimental data. METHODS: The wood samples were characterized using standard experimental procedures to determine their fuel properties. Five fuel evaluators relevant to the efciency of a pyro-gasifcation process, were developed. The experimental data collated for each sample was used to carry out an evaluation exercise of the samples under each of the fve fuel evaluators. Finally, the result of this exercise was used to rank the wood samples based on their suitability as feedstock for pyro-gasifcation. RESULTS: The hardwoods such as the Eucalyptus and African mesquite exhibited high fuel ratios, heating value and energy density which was as result of their higher lignin content. However, they exhibited minimal char reactivity. Conversely due to its higher holocellulose-to-lignin ratio, the Bugweed exhibited high char reactivity but lower fuel ratio, heating value and energy density. In comparison to the literature, the experimental results in this study were somewhat consistent with those of other biomass samples previously reported. The Fuel characterization exercise reveals that no wood sample can be considered completely efcient for pyro-gasifcation. The Jacaranda was however ranked lowest across the board. CONCLUSION: The variations in the hierarchy of the samples under the diferent fuel evaluators due to the disparities in their fuel properties paves way for further studies on the blending of waste wood samples with contrasting fuel properties in diferent mix ratios. This would enable the production of feedstock with the right balance in fuel properties suitable for an efcient pyro-gasifcation process. This study provides stakeholders with a framework for blending diferent lignocellulosic biomass species for thermochemical conversion.Item Feasibility assessment of the production of bioethanol from lignocellulosic biomass pretreated with acid mine drainage (AMD)(Elsevier, 2020-09-01) Burman, N.W.; Sheridan, C.; Harding, K.G.A techno-economic evaluation of a lignocellulosic bioethanol facility that uses acid mine drainage for the pre-treatment of weeping love grass (Eragrostis curvula) was performed. Both separate hydrolysis and fermentation (SHF) and simultaneous saccharification and fermentation (SSF) reactor configurations were evaluated. Results were compared to an evaluation of the same process with biomass pre-treated with dilute H2SO4. Capital and operating costs were estimated and a simple economic evaluation was conducted. It was found that all scenarios made a loss except for biomass pre-treated with H2SO4 in the SHF reactor configuration, although the high capital cost resulted in a payback period of 80.7 years, which is unfeasible. SHF was found to produce more ethanol at a lower capital cost than SSF, indicating that it is more economically feasible. Incorporating the remediation of AMD into a simultaneous process could help improve process economics. It is thus recommended that a techno-economic evaluation be conducted on a process that produces bioethanol through SHF and simultaneously remediates AMDItem Lignocellulosic Bioethanol Production from Grasses Pre-treated with Acid Mine Drainage: Modeling and Comparison of SHF and SSF(Elsevier, 2019-09-01) Burman, N.W.; Sheridan, C.M.; Harding, K.G.Acid mine drainage (AMD) was used for the pre-treatment of indigenous South African grass (Eragrostis curvula), and compared to H2SO4 (1 wt%) pre-treatment. The optimal pre-treatment duration were investigated and found to be 1 day for H2SO4 and 3 days for AMD pre-treatment. The optimal biomass solid loadings were found to be 20 wt% for both pre-treatment methods. Additionally, enzymatic hydrolysis and fermentation to produce ethanol were investigated for both separate hydrolysis and fermentation (SHF) and simultaneous saccharification and fermentation (SSF). In both SHF and SSF, the H2SO4 pre-treatment obtained higher concentrations of glucose/ethanol compared to AMD pre-treatment. The concentration of glucose/ethanol obtained using AMD pre-treatment was 70–80% of that achieved using H2SO4 pre-treatment. Empirical equations modeling the glucose/ethanol concentration in all processes were determined using a least squares method. Concentrations predicted by the models were found to have a high correlation (r2 = 0.87–0.99) to concentrations determined experimentallyItem Modelling of Low Temperature Dilute Sulfuric Acid Pre-treatment of South African Grass(Elsevier, 2018-12-01) Burman, N.W.; Sheridan, C.; van Dyk, L.; Harding, K.G.Dilute acid hydrolysis is an effective method of pre-treatment of lignocellulosic biomass. Although there are many studies modelling this pre-treatment at high temperature (120–210 °C), no studies were found modelling this reaction at low temperature. In this study, a long grass species was pre-treated with dilute sulfuric acid (pH 1, 2 & 3) at low temperatures (35 °C, 65 °C, 90 °C). The hydrolysis of xylan was found to obey a bi-phasic model in which there are two fractions of xylan, with significantly different hydrolysis rates. The rates of hydrolysis of the fast reacting fraction was found to obey Arrhenius type temperature dependence (Ea = 155.06 kJ/mol, A0 = 1.65 × 1019/min), which agrees with findings of similar studies at higher temperatures. A negligible rate of hydrolysis was determined for the slow fraction which differs from previous studies. The proportion of the slow reacting fraction (50%) which is lower than previously determined (55%–100%).Item Status and prospects of life-cycle assessments, carbon- and water footprinting studies in South Africa(Springer, 2021-01) Harding, K.G.; Friedrich, E.; Jordaan, H.; le Roux, B.; Notten, P.; Russo, V.; Suppen-Reynaga, N.; van der Laan, M.; Goga, T.Purpose Using the current state of life-cycle assessment (LCA), carbon-, water footprinting, and EPDs in South Africa, this work explores the challenges and opportunities for scholarly development in these areas in the country. Methods Being a relatively small LCA community in South Africa, academics, consultants, and other stakeholders were approached to provide lists of known studies, with further reports, that may have been missed, obtained through internet searches. Information was collated on database development, capacity building, and other aspects and presented here in a single paper. Results and Discussion While the authors are aware of companies working on LCA and related studies, hidden in confidential reports, we were able to find 27 LCA, 17 water-, 12 carbon footprinting, and 10 EPD studies. Although these studies have potential advantages for policymaking and business, their number, implementation, and impact remain limited. Conclusion While previously seen as an academic exercise, life-cycle thinking has been adopted by industry, private consultants, and the South African National Cleaner Production Centre (NCPC-SA), amongst others. Growing interest has led to the creation of several training courses available at academic institutes, the NCPCSA, and consulting firms, ranging from basic understanding to advanced use of software packages and modeling techniques. The development of a national LCI database, and further exposure and opportunity for LCA studies, are important steps to hopefully spur LCA in southern Africa in the future.