School of Chemistry

Permanent URI for this community

https://wiredspace.wits.ac.za/handle/10539/21118

Browse

Browsing School of Chemistry by Author "Cukrowska, E."

Now showing 1 - 2 of 2
  • Thumbnail Image
    Item
    Column adsorption studies for the removal of U by phosphonated cross-linked polyethylenimine: modelling and optimization.
    (Springer, 2015-03) Saad, D.M.; Cukrowska, E.; Tutu, H.
    A continuous fixed-bed adsorption study was carried out by using phosphonated cross-linked polyethylenimine as an adsorbent for the removal of uranium (U) from aqueous solutions. The effect of inlet metal ion concentration (40, 70, and 100 mg L-1), feed flow rate (1, 2, and 3 mL min(-1)), and polymer bed height (2.5, 3.2 and 4.5 cm) on the breakthrough characteristics of the fixed-bed adsorption system at pH 2 were studied. The results showed that the breakthrough time appeared to increase with increase of bed height but decreased with increase of both influent U concentration and flow rate. Modelling of the dynamics of the fixed-bed adsorption process was studied and the application of different models to describe the breakthrough curves showed that the Thomas and Yoon-Nelson model gave better results for the operating conditions.
  • Thumbnail Image
    Item
    Selective adsorption of uranium (VI) on NaHCO3 leached composite γ-methacryloxypropyltrimethoxysilane coated magnetic ion-imprinted polymers prepared by precipitation polymerization
    (South African Chemical Institute, 2015) Tavengwa, N.T.; Cukrowska, E.; Chimuka, L.
    Ion imprinted nano-magnetic composite polymers for selective removal of hexavalent uranium were prepared by a precipitation polymerization technique in the presence of γ-methacryloxypropyltrimethoxysilane (γ-MPS) coated magnetite and other pre-polymerization reagents. The synthesized magnetic polymers were then leached with NaHCO3 to produce magnetic ion imprinted polymers (IIPs) with fabricated adsorption sites complementary to the uranyl ions in terms of size and shape. Several parameters were investigated to obtain conditions which gave the optimum adsorption of the uranyl onto the magnetic IIPs and their corresponding controls, magnetic ion non-imprinted polymers (NIPs). The optimum amount of magnetic sorbent, initial concentration and contact time were 50 mg, 2.5 mg L-1 and 45 min, respectively. The adsorption capacity of the magnetic IIP (1.15 ± 0.01 mg g-1) was higher than that of the magnetic NIP (0.93 ± 0.02 mg g-1). This indicated that the former had a somewhat higher affinity for U(VI) than the later. The magnetic polymers also displayed good selectivity of the order: U(VI) > Ni(II) > Mg(II). After six cycles of use, the magnetic polymers illustrated good stability and reusability.