Research Outputs (Mechanical, Industrial and Aeronautical Engineering)

Permanent URI for this collection

https://wiredspace.wits.ac.za/handle/10539/21344
For information on accessing School of mechanical, industrial and aeronautical engineering Research Articles content please contact Salome Potgieter by email : salome.potgieter@wits.ac.za or Tel : 011 717 1961

Browse

Browsing Research Outputs (Mechanical, Industrial and Aeronautical Engineering) by Author "Rassmann, S."

Now showing 1 - 2 of 2
  • Thumbnail Image
    Item
    Effect of resin system on the mechanical properties and water absorption of kenaf fibre reinforced laminates.
    (Elsevier, 2011-03) Rassmann, S.; Paskaramoorthy, R.; Reid, R.G.
    The objective of this study is to compare the mechanical and water absorption properties of kenaf (Hibiscus cannabinus L.) fibre reinforced laminates made of three different resin systems. The use of different resin systems is considered so that potentially complex and expensive fibre treatments are avoided. The resin systems used include a polyester, a vinyl ester and an epoxy. Laminates of 15%, 22.5% and 30% fibre volume fraction were manufactured by resin transfer moulding. The laminates were tested for strength and modulus under tensile and flexural loading. Additionally, tests were carried out on laminates to determine the impact energy, impact strength and water absorption. The results revealed that properties were affected in markedly different ways by the resin system and the fibre volume fraction. Polyester laminates showed good modulus and impact properties, epoxy laminates displayed good strength values and vinyl ester laminates exhibited good water absorption characteristics. Scanning electron microscope studies show that epoxy laminates fail by fibre fracture, polyester laminates by fibre pull-out and vinyl ester laminates by a combination of the two. A comparison between kenaf and glass laminates revealed that the specific tensile and flexural moduli of both laminates are comparable at the volume fraction of 15%. However, glass laminates have much better specific properties than the kenaf laminates at high fibre volume fractions for all three resins used.
  • Thumbnail Image
    Item
    Effects of processing conditions on the mechanical and water absorption properties of resin transfer moulded kenaf fibre reinforced polyester composite laminates.
    (Elsevier, 2010-11) Rassmann, S.; Reid, R.G.; Paskaramoorthy, S.
    This paper focuses on the mechanical and water absorption properties of kenaf fibre reinforced polyester laminates manufactured by resin transfer moulding. Varying processing conditions were considered as alternatives to fibre treatments, thereby potentially avoiding additional cost and complexity in the manufacturing process. Laminates were produced by altering fibre moisture content, mould temperature and mould pressure following injection. Tensile, flexural, impact and water absorption tests were conducted. Processing conditions were found to have little effect on properties except for pressurisation which increased tensile and flexural strength and decreased water absorption at low fibre volume fractions. Examinations using a scanning electron microscope showed that all the laminates failed by fibre pull-out.