Madikizela, Chwayita2018-11-122018-11-122018Madikizela, Chwayita, (2018) Improving ductility and fracture toughness of as-built Ti-6AI-4V parts fabricated using powder bed fusion processes by in situ alloying, University of the Witwatersrand, Johannesburg, https://hdl.handle.net/10539/26001https://hdl.handle.net/10539/26001Submitted to School of Chemical and Metallurgical Engineering, Faculty of Engineering and the Built Environment, University of the Witwatersrand, Johannesburg May 2018Ti-6Al-4V is a titanium alpha-beta (α+β) alloy used in the aerospace industry. The CSIR-National Laser Centre encountered problems building large Ti-6Al-4V parts by additive manufacturing using the AeroswiftTM machine. The acicular αʹ microstructure of Ti-6Al-4V had low fracture toughness and ductility, resulting in the part being unable to withstand the residual stresses, and delaminating during processing. To solve this problem, in situ alloying of Ti-6Al-4V with a ductile beta (β) stabilizer, 10 wt% Mo, was investigated since the β phase is more ductile. Samples were manufactured on the powder bed fusion (PBF) and directed energy deposition (DED) platforms. A commercial β-Ti alloy (Ti-3Al-8V-6Cr-4Zr-4Mo) was also investigated for comparison. The Ti-6Al-4V, Ti-6Al-4V+10 wt% Mo and β-Ti alloy samples were manufactured on a selective laser melting (SLM) machine (PBF process), and Ti-6Al-4V+10 wt% Mo samples were made on a LENSTM machine(DED process). The samples were subsequently examined by optical, scanning electron microscopy (SEM) with electron diffraction X-ray spectroscopy (EDX) and electron backscatter diffraction (EBSD), X-ray diffraction (XRD), and were tested for hardness. Increased energy density changed the shape of pores, and decreased the porosity. The microstructure of PBF-produced Ti-6Al-4V+10 wt% Mo was inhomogeneous, with unmelted Mo particles and inconsistent hardness values, depending on Mo content. A PBF sample was tested for micro-galvanic corrosion, and the more Mo particles were attacked. Thus, no further testing was conducted on this alloy. The overall alloy hardness (302 HV0.3) was lower than for Ti-6Al-4V (360 HV0.3), indicating that Mo had a softening effect. When produced by DED, Ti-6Al-4V+10 wt% Mo was more homogeneous, with very little unmelted Mo, and hardness was higher (397 HV0.3) than for the PBF sample (302 HV0.3). The commercial β-Ti alloy had a fully β microstructure, with a 309 HV0.3 hardness, which was lower than that of Ti-6Al-4V (360 HV0.3). The ultimate tensile strength of Ti-6Al-4V (1130 MPa) was higher than for the commercial β-Ti alloy (863 MPa). The elongation of the commercial β-Ti alloy (30%) was much higher than Ti-6Al-4V (9%).Online resource (various pagings)enAlloys--MetallurgyThesis